The linear guide is a high -precision navigation accessory. Because it is rolling and the friction is small, the linear guide rails are used on many automated devices. Because it is simple and easy to use, we are also very convenient for us to operate. In addition, the installation of the straight line guide is also very convenient. We don't need too complicated craftsmanship, we only need to make simple adjustments. However, after installing the linear guide, some users will find that after a period of time, the size and accuracy of the size starts to decline. According to normal, this is a manifestation of negligence. Guidance products can bear loss for many years. There must be some problems. According to years of installation experience, the straight -line guide rail is believed to have a balance between balance during installation.
When installing a straight line guide, it should be very concentrated, otherwise it will cause uneven left and right, resulting in decreased accuracy and other reasons. When installing, the general operation method is to put the screws on all sides first, not tight or slow, at the same time tightly, you cannot tighten a single screw.
In addition, the straight -line guide should also pay attention to maintenance. The main purpose of maintenance is to reduce operating wear, so it is especially important for effective lubrication and daily maintenance. Details of Lubrication and maintenance of straight line guide:
1. Carefully wipe the oil stains on the surface of the straight line guide, especially the oil stains in the groove; pay attention to install the oil in the pores in a straight line guide.
2. Remove excess oil and heat the machine.
3. Fill the mouth of the mouth into the transmission cavity with the fat mouth until the internal oil is completely squeezed out. Clear the crowded oil.
4. Push the silk mother (sliding seat) many times before and after to ensure that the oil membrane is uniform.
5. Apply a little oil to the surface of the straight guide rail with your fingers to ensure that the groove is in a priority position.
